Followers
Powered by Blogger.
Wednesday, 19 December 2012
Solid-Film Lubricants Are Very Useful!
Where do you use solid-film lubricants and what are their advantages?
Solid-film lubricants are much more than low friction coatings: They can be used for metal wear protection, too. Especially when surface contact is severe and localized. This is the time when lubrication, not hardness alone, is key. Just think of the valves and seats in your car.A variety of solid materials with inherent lubricating capability are available for use in solid-film lubricants. The most commonly used are
Wednesday, 12 December 2012
What are the effects of mixing Synthetic and Mineral Oils?
You cannot mix Synthetic oil and mineral oil – or, can you?
![]() |
| Are "old" and new technologies compatible? |
But the truth is, the effect or consequence, depends on the types of synthetic bases that are mixed with the mineral bases. Polyalphaolefin and diester synthetic bases can quite happily be mixed with mineral oil bases. This is actually how “blended” products are created.
When should synthetic oil and mineral oil not be mixed?
Polyalkylene glycol (PAG) bases should notTuesday, 4 December 2012
How to prevent health problems when handling industrial lubricants.
Incorrect handling of lubricants can lead to quite serious health problems.
While exposure to some oils and greases carries little to no risk of health problems, incorrect handling of industrial lubricants could lead to health problems such as dermatitis and even respiratory problems.Workers, such as automotive technicians, who come into contact with lubricants on a daily basis should be trained and given the correct safety equipment in order to handle lubricants while preventing health problems
Knowledge is power when handling lubricants safely.
One of the best ways to preventWednesday, 28 November 2012
How to store and handle grease for best life
Handling and storage of grease has a major impact on the life of the product.
Like most materials, lubricating grease gradually will deteriorate with time. The rate and degree of deterioration depends on the storage and handling and storage of the greaseGrease may change its characteristics during storage. The product may oxidize, bleed, change in appearance, pick up contaminants or become firmer or softer. The amount of change varies with the length of storage, temperature and nature of the product.
What effects do handling and storage of the grease have?
Depending on the storage conditions,Wednesday, 21 November 2012
Are You Aware Of The Hidden Cost Of Changing Oil?
Few companies understand the hidden cost of oil changes.
When it comes to the the cost of changing oil many companies merely look at material costs and the direct labour component of the lube change. They are ignoring the significant hidden costs that must also be taken into consideration when managing lubrication schedules and maintenance.Too often, we schedule an oil change to rectify a contamination problem or when excessive wear is detected. In neither case is the oil change a certain correction of the root cause
Wednesday, 14 November 2012
How To Store Oil Drums Outside
To save costs many companies are storing their oil drums outside.
It’s cheap to store oil drums outside, and anyway they’re sealed so nothing can go wrong.As many a company has learnt through costly experience storing oil drums outside is not that simple... or safe.
The practice of storing oil drums outside creates a high risk of water ingress into the new oil, if the drums are not stored properly. This is especially true during the summer months, when the temperature of the drums can soar to
Wednesday, 7 November 2012
Can changing to synthetic engine oil damage seals?
Will changing to synthetic engine oil damage the seals?
Owners of recently purchased pre-owned cars often want to start off with a fresh charge of synthetic motor oil, but are worried that synthetic engine oil damages seals.Many people believe that switching a higher mileage engine from a conventional oil to a Group IV synthetic polyalphaolefin (PAO) can lead to seal leakage: but is there less inherent risk with switching to a Group III oil? The rational here
Subscribe to:
Posts (Atom)






